Modine PDP150LP Bedienerhandbuch Seite 1

THIS MANUAL IS THE PROPERTY OF THE OWNER. PLEASE BE SURE TO LEAVE IT WITH THE OWNER WHEN YOU LEAVE THE JOB. Inspection on Arrival1. Inspect unit upo

106-560.4INSTALLATION - GAS CONNECTIONSGAS CONNECTIONS1. Installation of piping must conform with local building codes, or in the absence of local co

116-560.4INSTALLATION - HIGH ALTITUDE ACCESSORY KITHIGH ALTITUDE ACCESSORY KITAltitude (ft)Gas Heating Values at Altitude (BTU/ft3)USA Canada0-2,000 1

126-560.4INSTALLATION - HIGH ALTITUDE ACCESSORY KITIf the heating value of the gas being supplied is different than the values shown in Tables 11.1 an

136-560.4INSTALLATION - ELECTRICAL CONNECTIONS Amp draw data shown is operating amp draw at incoming power. For units that use a field installed acce

146-560.4INSTALLATION - OPERATIONAlthough this unit has been assembled and fire-tested at the factory, the following pre-operational procedures should

156-560.4CONTROL OPERATING SEQUENCE / UNIT COMPONENTSUpon a call for heat from the thermostat, power is supplied to the power exhauster motor. The uni

166-560.4Figure 16.1 - 30°, 60°, and 90° Downward Deflector Hoods HSSMOUNTINGHEIGHTXYYZZX60 DOWNTURN30 DOWNTURNNote:X = Feet from Heater to Start of

176-560.4DIMENSIONAL DATA - MODEL PTPPropeller Units - Model PTPFigure 17.1 - Dimensional Drawings A F H B POWER VENTERVENT PIPE CONNECTIONACCESS

186-560.4SERVICE / MAINTENANCE / TROUBLESHOOTINGGeneral MaintenanceThe unit and venting system must be checked once a year by a qualified service tech

196-560.4Model SizePower ExhausterLimit Control Switch Pressure SwitchIgniterIgnition Control (1 Stage)Combination Gas Valve (1 Stage)Ignition

26-560.4SPECIAL PRECAUTIONSSPECIAL PRECAUTIONSTHE INSTALLATION AND MAINTENANCE INSTRUCTIONS IN THIS MANUAL MUST BE FOLLOWED TO PROVIDE SAFE, EFFICIEN

Modine Manufacturing Company1500 DeKoven AvenueRacine, WI 53403 Phone: 1.800.828.4328 (HEAT) www.modinehvac.com© Modine Manufacturing Company 2014As M

6-560.4In the U.S., the installation of these units must comply with the National Fuel Gas Code, ANSI Z223.1 (NFPA 54) - latest edition and other appl

6-560.4Location Recommendations1. When locating the heater, consider general space and heating requirements, availability of gas and electrical suppl

56-560.41. Be sure the means of suspension is adequate to support the weight of the unit (see page 17 for unit weights). 2. For proper operation,

66-560.4A4. Refer to Table 6.1 for total minimum and maximum vent lengths, making the system as straight as possible. The equivalent length of a 90°

6-560.4A9. When the vent passes through a combustible INTERIOR wall or floor, a metal thimble 4" greater than the vent diameter is necessary

86-560.4Section B – Vertical Vent System InstallationB1. This section applies to vertically vented Category I vent systems and is in addition to “Sect

96-560.4Section C – Horizontal, Category III Vent System InstallationC1. This section applies to horizontally vented Category III vent systems and is